Error
  • JUser: :_load: Unable to load user with ID: 77

Friday, 10 February 2012 10:01

Removing and Replacing Transport Bolts

Category: Operation & Use
Topic: Centrifuge Installation & Set-up

A brief tutorial on how to remove and replace the transport bolts of your Hettich centrifuge. This video pertains to the EBA 20s Centrifuge model. Any questions please contact Hettich service ( This email address is being protected from spambots. You need JavaScript enabled to view it. ).
Friday, 10 February 2012 09:49

Unpacking of Centrifuge

Category: Operation & Use
Topic: Centrifuge Installation & Set-up

A brief tutorial on how to unpack your Hettich centrifuge. This video pertains to the EBA 20 Centrifuge model. Any questions please contact Hettich service ( This email address is being protected from spambots. You need JavaScript enabled to view it. ).

Category: Other
Topic: General

Hettich Centrifuges use brushless DC motors controlled by a device known as a Frequency Converter.

Friday, 21 October 2011 09:06

Disposal of Centrifuge

Category: Symbols & Markings
Topic: Symbols

Before disposal, the centrifuge must be decontaminated and free of any bio- or radioactive hazard to protect people, the environment and property.

Category: Operation & Use
Topic: Centrifuge Operation

The running time, the speed, the relative centrifugal force (RCF), the centrifuging radius, the run-up and run-down parameters as well as the temperature (for centrifuges with cooling only) can all be changed while the centrifuge is running.

Friday, 21 October 2011 09:03

Continuous Operation

Category: Operation & Use
Topic: Centrifuge Operation

The run time can be set to continuous using the following steps:

Friday, 21 October 2011 09:01

Definition of Mains Reset

Category: Operation & Use
Topic: Centrifuge Operation

A mains reset is the removal and re-application of AC power via the power switch.

Friday, 21 October 2011 09:00

Emergency Stop

Category: Operation & Use
Topic: Centrifuge Operation

The centrifuge will invoke the highest braking intensity (9) by pressing the STOP key twice.

Friday, 21 October 2011 09:00

Entering or Changing Programs

Category: Operation & Use
Topic: Centrifuge Operation

User created programs can be stored for use in most centrifuges. The programs are stored values of each of the centrifuge parameters that can be recalled quickly without having to reprogram each individual parameter.

Category: Quality & Safety
Topic: Centrifugation Safety

Hettich centrifuges are designed to spin a variety of centrifuge tubes and accessories. Particular attention should be used when spinning glass tubes and containers to avoid breakage within the centrifuge's main chamber.

Page 1 of 2